Update 4.3.09_dev

1 vote, average: 5.00 out of 51 vote, average: 5.00 out of 51 vote, average: 5.00 out of 51 vote, average: 5.00 out of 51 vote, average: 5.00 out of 5 (1 votes, average: 5.00 out of 5)
You need to be a registered member to rate this post.
Loading...
Posted by :MagoKimbra On : 16th December 2016
2

Category: Firmware

Shares

Version 4.3.09_dev

* Add Save in EEPROM ABL (Linear or Bilinear) or MBL

* Add M321 Set Level bilinear manual – X Y Z S

* Add Door open, a triggered door will prevent new commands from serial or sd card.

* Fix HAL

M320 S0 – enable ABL

M320 S1 – disable ABL

M320 Z1.5 – Set fade height at 1.5 mm (if Enable ENABLE_LEVELING_FADE_HEIGHT)

M320 V – verbose print Bilinear Level Grid

M321 – print grid in current position and z value

M321 X2 Y5 Z0.1 – set 0.1 in grid(2, 5)

M321 Z0.1 – set 0.1 in grid(current position)

M321 X2 Y5 S0.1 – add 0.1 at valor in grid(2 , 5)

M321 S0,1 – add 0,1 at valor in grid(current position)

M322 – Reset ABL

 

Previous Post

Next Post

Related Posts

Related posts:

  1. Update V4.3.08_dev
  2. Update v4.1.4
  3. Update v4.1.3

Comments (2)

  1. rosario3dprt
    17th December 2016 at 19:06

    Ciao Mago,

    sbaglio o in passato dicesti che avresti pubblcato una guida per il MBL?

    Ho un piatto grande e con l’ABL non ho la precisione che mi serve. Se non ho capito male con il Mash posso migliorare la granuralità della griglia e livellare meglio per singoli punti.

    Grazie in anticipo

    Rosario

    Log in to Reply

Leave a Reply

Shares