MK4duo

New Version 4.4.0

0 votes, average: 0,00 out of 50 votes, average: 0,00 out of 50 votes, average: 0,00 out of 50 votes, average: 0,00 out of 50 votes, average: 0,00 out of 5 (0 votes, average: 0,00 out of 5)
You need to be a registered member to rate this post.
Loading...
Shares
  • Revision 24-01-2020
  • Version EEPROM MKV79
  • Version Nextion 1_3_1
  • Add Nextion 7″ Intelligent
  • Start development for STM32 on board Rumba32
    • Hardware Timer for stepper OK
    • Systick for temp OK
    • PWM Hardware OK
    • SD OK
    • Serial OK
    • EEPROM on FLASH OK
    • Display Nextion OK
    • DHT OK
    • SERVO OK
    • BLTOUCH OK
    • DISPLAY 20×4 No Test
    • DISPLAY Graphics Function
    • Neopixel Not function
  • M353: Set total number Extruder, Hotend, Bed, Chamber, Fan
    • D[int] Set number driver extruder
    • E[int] Set number extruder
    • H[int] Set number hotend
    • B[int] Set number bed
    • C[int] Set number chamber
    • F[int] Set number fan
  • M563: Set Tools heater assignment
    • T[tools] – Set Tool
    • D[int] – Set Driver for tool
    • H[bool] – Set Hotend for tool
  • M890: Run User GCode
    • S[int] – Run 1 – 5 user gcode
  • M900: S[bool] Active Linear Advance Test see new valor in configuration LIN_ADVANCE_K_START and LIN_ADVANCE_K_FACTOR
  • Add multiple Language, max 5, for lcd..
  • Rename DELTA_SEGMENTS_PER_SECOND in DELTA_SEGMENTS_PER_SECOND_PRINT for delta print
  • Add DELTA_SEGMENTS_PER_SECOND_MOVE for delta move
  • Add Linear advanced K-Factor for Extruder
  • Add Nextion Baudrate
  • Add Nextion CRC on serial
  • Fix JUNCTION_DEVIATION
  • Fix BABYSTEPPING
  • Fix M569 code for extruder
  • Add Vref on STM32 for ADC
  • Fix Alligator V2 DAC
  • Fix problem with STM32core 1_8_0
  • Fix problem with TOOL_CHANGE_FIL_SWAP
  • Fix and clear code

Next Post

Comments are closed.

Shares